The ATC Model 655 timer is an electronic control that will retrofit most round case electromechanical timers. The control performs the same timing modes (ON-Delay or Reverse Start Delay) as electromechanical units, and it is capable of timing ranges from 1 millisecond to 199 hours, 59 minutes. On the bottom inside of the control are DIP switches which can be set, in seconds, to establish the timing mode and time range. Our unit will plug into competitive mounted cases without wiring changes in most instances. Remove the electromechanical timer, set ours, plug it into the electromechanical timer case and you’re ready to run. DIP switch setting instructions for electromechanical timers are supplied with 655 installation instructions.
Documents
Related Products

655-8-1000
Solid-State Timer (120V AC)

655-8-1001
Solid-State Timer (240V AC)

655-8-3000
Solid-State Timer (120V AC)
Customers Also Viewed

WPCP204018G.U
$120.08
MSRP:
$148.24
Polycarbonate enclosure 400x200x187mm (15.7x7.9x7.4 inch) with grey cover, hinges and latches, UL-listed, IP66/67.
15.7in x 7.9in x 7.4in

AMP1226CCF
$82.98
MSRP:
$101.20
Polycarbonate enclosure with 4-screw lift-off clear cover
12in x 12in x 6in

WPCP406018T.U
$225.91
MSRP:
$278.90
Polycarbonate enclosure 600x400x187mm (23.6x15.7x7.4 inch) with transparent cover, hinges and latches, UL-listed, IP66/67.
23.6in x 15.7in x 7.4in

WPCP404018G.U
$143.10
MSRP:
$176.67
Polycarbonate enclosure 400x400x187mm (15.7x15.7x7.4 inch) with grey cover, hinges and latches, UL-listed, IP66/67.
15.7in x 15.7in x 7.4in

WPCP202013G.U
$49.44
MSRP:
$61.04
Polycarbonate enclosure 200x200x132mm (7.9x7.9x5.2 inch) with grey cover, hinges and latches, UL-listed, IP66/67.
7.9in x 7.9in x 5.2in

AMP443CC
$33.14
MSRP:
$40.41
Polycarbonate enclosure with 4-screw lift-off clear cover
4in x 4in x 3in